Airius System 35 Guía de instalación descargar pdf (Pagina 14)

Suggested Installation Methods

Remove the Air Pear from its box, then remove

the plastic protective bag. The bail (handle) is

attached via two Torx screws. Using T-30 Torx

driver, loosen these screws enough so the bail

may swing.

Swing the bail to the vertical position and

re-tighten the two Torx screws.

The Air Pear system is designed to hang

vertically and freely 12-to-18 inches, or as close

as possible, from the ceiling on professionally

installed hardware, for models 10/15/25, capable

of supporting a minimum of five times the weight

of the Air Pear unit, 60 lb (27 kg). Example - 1/4”

(7 mm) diameter steel bolt is rated at 60 lb (27 kg)

load.

A feature of the Air Pear system is its flexibility.

Hardware that may be used to hang the unit

includes, but is not restricted to: Hooks, chains,

cables, carabiners, bridle rings, beam clamps

and bolts. Roof structure, building construction

and accessibility will define the appropriate

hardware for each installation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

Airius System 35 Guía de instalación Pagina 14